Once booted the system runs fine and if I restart it'll reboot quickly and normally but if I switch off at the power and restart it'll cycle and hang again and if I go into BIOS settings after it starts cycling it says "BIOS had been reset, check settings"įrustratingly it seesm to hang with number 07 shown on the MB display but there's no 07 in the error codes which only start at 10. Press on this item and select Ye s to load the optimal BIOS default settings.![]() This saves the changes to the CMOS and exits the BIOS Setup. On the right side is the list of sub-menus that can be accessed by pressing the corresponding F-key or using the mouse. It gives you the ability to set the memory XMP profile and fan control without digging deeply into the sub-menus. I've cleaned and re-seated the CPU and all RAM sticks, ran Memcheck (27hours.) all good, booted with individual RAM sticks only, no difference, flashed the latest BIOS version (F13a) cleared CMOS and replaced the MB battery and tried booting with RAM XMP profile enabled and disabled all to no avail. View the Gigabyte X570 Aorus Pro manual for free or ask your question to other Gigabyte X570 Aorus Pro owners. The Gigabyte Z690 AORUS Master has an easily understood BIOS EZ Mode that is the default landing screen. It seems to be cycling twice then starting on the third boot (see link at bottom). ![]() ![]() ![]() My PC usually boots to windows in about 20 secs or so but a few months ago it started hanging in BIOS for ages before even showing the splash screen to the point where it takes over a couple of minutes to boot now.
0 Comments
Leave a Reply. |